⚠️ Important Notice


Your IP address and browser information will be recorded as proof of this acknowledgement. This data is retained for 12 months.

🟢 SOLVED: Power window stopped working — motor, regulator or switch? | MyCarFault
🟢 SOLVED 80% 1 fix reported · 45 driver confirmations

🟢 Power window stopped working — motor, regulator or switch?

On This Page: 🔍 Symptoms ⚙️ Causes 🔧 All Repairs ⚠️ Avoid These 🧾 Driver Reports 📖 Repair Guides
⚡ Quick Summary
Severity Level
Medium
Safe to Drive?
⚠️ Drive with Caution
Safety Impact
Indirect risk — worth monitoring, not urgent
Urgency Level
🟡 Monitor Closely

Driver power window stopped going down. Goes up fine but will not go down. Or stuck in one position. This fault code is stored when the engine control unit detects a specific fault condition. Common causes include sensor failures, wiring faults, and component wear. Always read additional fault codes before replacing parts — multiple codes together provide a clearer diagnosis. Clear the code after repair and test drive to confirm the fault does not return.

🔍 Symptoms

📍 Multiple

⚙️ Possible Causes

Multiple Possible: Window motor or regulator failure. Test: 1) Try all windows — if all fail, check fuse and window lockout switch. 2) If only one window — listen for noise when pressing switch. Grinding or clicking = bad regulator. Silence = bad motor or switch. 3) Test sw

Onarım / Çözüm

Based on 45 driver confirmations

Window motor or regulator failure. Test: 1) Try all windows — if all fail, check fuse and window lockout switch. 2) If only one window — listen for noise when pressing switch. Grinding or clicking = bad regulator. Silence = bad motor or switch. 3) Test sw 0%
0 worked · 0 did not · ⚪ Unverified

⚠️ Yanlış Teşhis mi?

No commonly reported misdiagnoses for this fault yet. If you have replaced a part that did not fix this problem, submit a wrong diagnosis report — it helps other drivers avoid the same costly mistake.

🧾 Driver Reports

✅ Fixed Window motor or regulator failure. Test: 1) Try all windows — if all fail, check fuse and window lockout switch. 2) If only one window — listen for noise when pressing switch. Grinding or clicking = bad regulator. Silence = bad motor or switch. 3) Test sw

Window motor or regulator failure. Test: 1) Try all windows — if all fail, check fuse and window lockout switch. 2) If only one window — listen for noise when pressing switch. Grinding or clicking = bad regulator. Silence = bad motor or switch. 3) Test switch with multimeter. Window regulators fail more often than motors on modern cars. Cost: Regulator with motor assembly $80-200 parts, 1-2 hours labor.

Bu yardımcı oldu mu? 0 votes

📖 Related Repair Guides

Deneyiminizi paylaşarak diğer araç sahiplerine yardım edin.

Your real-world fix helps thousands of drivers worldwide. Takes 2 minutes.

🔧
Usta
● Online