Your IP address and browser information will be recorded as proof of this acknowledgement. This data is retained for 12 months.
Timing chain rattle on cold start on Nissan Qashqai with 1.6 dCi diesel engine. Chain stretch and tensioner failure known issue. This fault code is stored when the engine control unit detects a specific fault condition. Common causes include sensor failures, wiring faults, and component wear. Always read additional fault codes before replacing parts — multiple codes together provide a clearer diagnosis. Clear the code after repair and test drive to confirm the fault does not return.
Based on 0 driver confirmations
No commonly reported misdiagnoses for this fault yet. If you have replaced a part that did not fix this Nissan problem, submit a wrong diagnosis report — it helps other drivers avoid the same costly mistake.
Had the cold start rattle for about 6 months before finally getting it looked at. Expected the worst. Specialist said the chain was stretched but the guides were still intact. Full chain kit replaced. Lucky it hadn't jumped. Don't wait as long as I did.
Parts replaced: Timing chain, tensioner, guides
Rattle on cold start that lasted about 15 seconds. Didn't ignore it. Specialist confirmed chain and tensioner wear. Had it done. Not cheap — £900 — but a lot cheaper than a new engine. The rattle is your warning, don't ignore it.
Parts replaced: Timing chain, tensioner, guides
Your real-world fix helps thousands of drivers worldwide. Takes 2 minutes.