⚠️ Important Notice


Your IP address and browser information will be recorded as proof of this acknowledgement. This data is retained for 12 months.

Hard start when cold — carburetor choke issue — Mercedes-Benz W115 (1968–1976) | MyCarFault
🚗 Classic Fault — Mercedes-Benz W115 (1968–1976)

Hard start when cold — carburetor choke issue

🟢 Solved Easy 🏁 Original spec 1.5 hrs
Community fix rate — 14 confirmed fixes
78% success rate
💰 Estimated Repair Cost
$20 – $80 USD
Parts and labour estimate
🔧 Tools Required
Screwdrivers, choke thermometer, multimeter
📋 Overview

The W115 230.4 commonly fails to start on first or second attempt when cold, especially below 10C. The engine cranks normally but does not fire, or fires briefly then stalls. This is almost universally a choke-related issue on the twin Zenith 35/40 INAT carburetors.

🩺 Symptoms
🔍 Possible Causes
🛠️ Diagnosis Steps
  1. Check choke flap position — should be nearly closed when cold.
  2. Test bimetal spring tension.
  3. Check choke pull-off diaphragm for cracks.
  4. Verify choke heater element resistance 40-60 ohms.
  5. Adjust choke if needed.
Most Confirmed Fix

Replace choke pull-off diaphragm and re-adjust choke bimetal spring. Clean choke housing.

78% of users confirm this fix worked (14 reports)
🏷️ Parts Needed

Zenith 35/40 INAT choke pull-off diaphragm kit

🩺 Related Symptoms


⛽ Carburetor Hesitation ⛽ Hard Cold Start

🔗 Other Mercedes-Benz W115 Faults


Own a Mercedes-Benz W115?

Share your experience with this fault — or report a different issue. Your knowledge helps other classic car owners worldwide.

🔧
Usta
● Online