⚠️ Important Notice


Your IP address and browser information will be recorded as proof of this acknowledgement. This data is retained for 12 months.

Honda Civic EG D-series distributor failure — no start — Honda (1991–1995) | MyCarFault
🚗 Classic Fault — Honda (1991–1995)

Honda Civic EG D-series distributor failure — no start

🟢 Solved Moderate 🏁 Original spec 2 hrs
Community fix rate — 22 confirmed fixes
88% success rate
💰 Estimated Repair Cost
$70 – $200 USD
Parts and labour estimate
🔧 Tools Required
New or remanufactured distributor, timing light
📋 Overview

The internal electronics of the D-series distributor including the crank angle sensor and igniter module fail, causing no-start or intermittent cutting out.

🩺 Symptoms

Engine cranks but will not start. Intermittent cutting out while driving. No spark on all cylinders.

🔍 Possible Causes

Igniter module failure from heat. Crank angle sensor wear. Distributor bearing wear.

🛠️ Diagnosis Steps

Confirm rotor is turning when cranking (timing belt is intact). Test for spark at coil output. Swap distributor as a unit to confirm.

Most Confirmed Fix

Replace distributor assembly. Index correctly to timing marks. Verify timing with timing light.

88% of users confirm this fix worked (22 reports)

🔗 Other Honda Faults


Own a Honda ?

Share your experience with this fault — or report a different issue. Your knowledge helps other classic car owners worldwide.

🔧
Usta
● Online